The Maintenance And Maintenance Work Of The Hydraulic Packer

 First, its maintenance work is introduced in detail. hydraulic cardboard baling machine china works to remove debris or dirt for maintenance from one week to 10 days.

Second, one month after the hydraulic baler works normally, the cleaning, maintenance and lubrication of the upper slide, middle knife and front ejector described in the previous paragraph will be performed once. The third is to perform all maintenance on the shaft (heart) and bearings every three months, except for the above two maintenances.

The hydraulic packer replenishes the oil in the gearbox of the reducer every two years. Also note that several parts cannot be refueled: rollers and reels, all belts, sliders and surrounding.

Cards may appear when the hydraulic packer is working properly. For example, how to handle horizontal waste paper hydraulic balers? Below, Belik teaches you how to deal with it. The horizontal waste paper packing tape is stuck in the center of the roller, or there is a foreign matter blocking the box. Loosen the countersunk head screws on the central connecting shaft, remove the connecting shaft, pick up the upper turbine, and remove the stuck object.

Hydraulic packers cannot form a belt without proper wear. Hydraulic packer equipment has been in use for a long time and has not been cleaned and maintained in a timely manner. As a result, swags are present in the machine, which makes the belt non-smooth and does not form. Using a belt, the horizontal waste paper baler can be completely cleaned and returned to normal.

Some hydraulic balers sometimes have problems, such as not actively feeding the belt. First check whether the potentiometer for belt length control is at the zero position. The potentiometer for belt length control is located at the left side of the front panel switch card. If it is at the zero position, it will not be performed.

China sorting machine MSW supplier believes that hydraulic balers have advantages and disadvantages in both vertical and horizontal styles.

The hydraulic packer has a horizontal packer and a vertical packer. The hydraulic packer is simple and complete, which can increase the total power of the packaging and save the labor cost of packaging. The hydraulic packer lead frame consists of four sets of wire equipment installed on the frame. The entire lead frame is suspended on the central axis of the press frame and moves horizontally relative to the press frame under the action of a hydraulic motor. The frame is a welded part with wheels at the bottom and moves horizontally along the main track as the hydraulic cylinder advances. Hydraulic balers are usually used to receive and manipulate compressed cardboard, waste film, waste paper, foam plastics, beverage cans and industrial decoration. With the advancement of technology, industrial development and the use of balers. Therefore, the baler has also been recognized by more and more people. It is used more and more widely.

Waste Recycling Equipment Factory

Hydraulic baler and horizontal waste paper hydraulic baler. As a result, this results in higher vertical packaging costs and lower power. The atmosphere of the hydraulic packer in the oil mixture or in the hydraulic cylinder is not completely exhausted. The hydraulic packer produces a cavitation phenomenon under the high pressure effect and generates a large noise. Whether it is a horizontal baler or a vertical baler, it has its own advantages and disadvantages, such as the low cost of a vertical baler, a small footprint, the high cost of a horizontal baler, and a large footprint.

The hydraulic packer is used to squeeze waste paper and similar products under normal conditions and is packed with special packaging tape to reduce volume, thereby reducing transportation volume, saving freight and increasing corporate profits. purpose. However, some operators and controllers are more casual, especially in the hot summer, especially when they work barefoot everywhere, but this is very dangerous, not only because the debris on the ground straps can stab feet, but more importantly if The floor is wet and easy to connect. Lead to very serious consequences.

Second, the wire connector is not fixed. In the production hall, the equipment is sometimes far from the power source, or the original wires are not long enough. At this point, the wires are connected, but the operator saves the connected wires directly to save time. Driving on the ground without following the direction of the wiring duct is very dangerous. The working conditions of waste paper balers are usually not very good, and all minor safety issues are easily overlooked, causing unnecessary losses.