It Is Explained That Full Automatic Baler Adopts Full Automatic Design

Fully automatic packing machine such as Waster Sorting System,it adopts fully automatic design, simple operation and use, high durability, perfect packing function. The strapping machine is a machine that USES strapping tape to wrap the product or package, and then tighten and connect the two ends through thermal effect melting or using buckle and other materials, so that the plastic belt can be close to the surface of the strapping package, ensuring that the package will not be scattered due to the weak strapping during transportation and storage, and at the same time, it should be tied neatly and aesthetically.

Although the machine is durable, but with the growth of the use of time, mechanical wear, there will be some failure of the automatic baler, the following is a brief analysis of the common automatic baler maintenance methods, convenient for everyone to use:

One: Cassette processing

When the belt is stuck in the middle of the roller, or there is a foreign body that cannot be removed, disassemble the washer of the hexagonal nut and loosen the two M5 countersunk head screws on the middle connecting shaft. Since these two screws are fixed in the gap part of the connecting shaft, the screws must be turned on; Remove the connecting shaft and pick up the upper turbine to remove the stuck object. Finally, the assembly can be restored according to the above method. Note that the clearance between the nut and l-shaped bending plate should be 0.3-0.5mm.

                                                     

Two: Tied after the cut belt

There are many circumstances that can cause this situation, such as: 1. 2. If there is oil in the sliding disc or belt, the oil must be removed; 3. If the belt is too tight, lower the belt driving seat or adjust the motor back;

Three: Poor bonding effect

1. The temperature of the Waster Treatment Machine is too high or not high enough, sometimes the special tape has poor viscosity, and the temperature must be very accurate;

2. The use voltage is not enough. The voltage in many factories is often insufficient.

3. The electric heating steel sheet is too high and too low, or left and right, so it meets the upper and lower PP belt, or left and right cutting tools, and cannot enter the heating, shall be adjusted according to the situation;

4. The smoke exhaust fan malfunctioned, making the temperature too high.

Four: Automatic packing machine can not take out

In this case, first check whether the "out band length adjustment" is at "0", and then see through the tape process is correct; If not, see if there is a foreign object stuck near the belt roller, this will also cause this situation.